Maintenance Schedule for Wheel Straightener
Make sure to turn off the power before all maintenance work!!
1. Maintenance Check List – Once a Day
1-A. When lathe is powered up, Check & Verify if Auto Lubrication Unit is ON(Green LED ON)
Also, the oil level should be above the minimum.
1-A. Add lubrication oil daily to the leadscrew, 6-jaw chuck and main spindle of the wheel straightener efore starting using the machine.
1-C. Check and verify the workable compress air pressure around 135 PSI before flipping the main spindle.
1-D. Clean the entire wheel straightening machine for each work shaft (8 hours).
2. Maintenance Check List – Once a Week
2-A. Add lubrication oil to the air cylinder and lock pin at the top position of the wheel straightening machine.
2-B. Add lubrication oil to the air cylinder and lock pin at the lower seat position of the wheel straightening machine.
2-C. When the lateral cylinder is not used for daily operations, turn the yellow handle to vertical position and disconnect the small cylinder from the valve.
2-D. Remove the golden color bracket from the machine when it is not used.
3. Maintenance Check List – Once a Month
3-C. Carefully check and adjust the tension for the chain associated with the large hand wheel to move the hydraulic ram.
3-D. Add grease to the area when the steel change and gears are located for turning the hand wheel.
4. Maintenance Check List – Every 3 Months
4-A. Check and adjust tension of two cables associated with the CENTER handle and LOCK handle when one is going to install or remove the rim from this machine.
4-B. Check and adjust working positions of springs connected with two steel cables for CENTER and LOCK handles.
4-C. Examine two lock pins located at the main spindle and 6-jaw chuck assembly.
4-D. Examine the limit switch position which is used for flipping the spindle to upside down position.
